ISOMETRIC MICRO FINISH COATING CO
A CAPSULE PROBLEM SOLVER (FDA APPROVED)
BOSCH DMW + SYNTEGON CAPSULE FILLERS ALL MAKES AND MODELS
Bosch GKF 330, 400, 700, 701, 702, 705, 1200, 1400, 1500, 2000, 2500, 2600, 3000
CAPSYLON 705, 1505, 3005 DMW 700, 1500, 2000
DO YOU HAVE A PROBLEM WITH CAPSULE PRODUCTION WHICH FALLS INTO ONE OF THE FOLLOWING CATEGORIES:?
Sticking, Build-Up, Weight Variation, Capsule Separation or Tamping Ring Friction
Sticking to the face of tamping pinsProduct build-up inside of dosing disk boresCapsule separation do to sticky or abrasive granulation in segment boresTamping Ring Friction due to abrasive granulationExcessive down-time to remove, clean, and buff toolingReduced running speeds due to sticking build-up and weight variation Excessive weight variation when running at higher speedsExcessive tamping pins and dosing disk wear due to hard or abrasive granulationHigh numbers of rejects due to sticking and build-up
We can help solve your problem without a formulation change
Isometric Developed a treatment to eliminate and prevent sticking, build-up, weight variation and capsule separation
---SPECIALIZING IN---
Dosing Disks
Tamping Pins
Upper Segments
Lower Segments
Tamping Rings
Sorting Blocks
Sorting Fingers
Magazines
RESULTS AFTER ISOMETRIC TREATMENT
Isometric Coating gives tamping pins face a mirror finish which eliminates sticking and build-up
Isometric Coating gives dosing disk bores a slippery mirror anti stick surface which eliminates build-up and weight variation problems.
Isometric Coating gives segment bores a slippery mirror anti stick surface which eliminates build-up, weight variation, and capsule separation issues.
Isometric Coating gives Tamping Rings a mirror surface that will eliminate friction and discoloration.
ISOMETRIC COATING WILL SOLVE ALL YOUR STICKING, BUILD-UP, WEIGHT VARIATION, CAPSULE SEPERATION, AND FRICTION PROBLEMS, AND WILL INCREASE YOUR BATCH YIELD TO 95% OR HIGHER
Contact: leo@isometriccoating.com - (732)306-6339